HOME | DD
randomproxy — Custom Munny - Naciliya
Published: 2011-02-17 19:42:53 +0000 UTC; Views: 774; Favourites: 11; Downloads: 10
Redirect to original
Description
Custom 4-inch Kidrobot Munny of my night elf druid, Naciliya.I didn't make the Ashbringer - it's from the Gnome Warrior Sprocket Gyrospring figure by DC Direct. (Why's a druid holding the Ashbringer, you say? I'm just a wee bit obsessed with the Argent Dawn... I haven't taken that tabard off for anything but championing reputation since I earned it in June 2006.)
Acrylics over vinyl and polymer clay.
Related content
Comments: 9
How did you stick the clay ears an the headrag to the munnies head???
👍: 0 ⏩: 1
The ears and eyebrows are supported with strips of 18 gauge jeweler's wire, which is wrapped in 24 gauge jeweler's wire. (The smaller wire gives some texture for the clay to stick to - otherwise it'd just peel off from its own weight.)
The tabard and the rest of the hair is Super Sculpey formed directly on the vinyl and baked on. (I bake my Super Sculpey at a lower temperature and for a longer time than the package directs, so I don't risk melting the vinyl.)
👍: 0 ⏩: 1
so wat would u recomend i bake at if i were useing FIMO Puppen Miniature clay??? "Once modelled, place in a preheated oven at 110 degrees celcius or 230 degrees farenheit for approximately 30 minutes" this is wat it says
👍: 0 ⏩: 1
I've never tried FIMO, to be honest. You might want to test some pieces to see how it cures.
👍: 0 ⏩: 1
